Larson Electronics EPL-24-50LED Instructions

Larson Electronics LLC
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
These instructions contain important safety information, read and follow them carefully. Larson
Electronics' will not accept responsibility for injury, damage, or loss which may occur due to incorrect
installation, operation or maintenance.
INTRODUCTION
This Linear LED light is designed for illumination of industrial locations. It uses the latest in solid state
lighting technology for long life, low maintenance, and high efficiency.
The unique optical design focuses light downward to where it is needed, giving improved efficiency over
a conventional HID luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 100V-277V, 50/60Hz AC supply without any variation in light output.
NOTE: Save these instructions for future reference.
INSTALLATION
WARNINGS:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:

Be certain electrical power if OFF before and during installation and maintenance.

Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:

Make sure the supply voltage is within the luminaires' voltage rating.

Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.

Do not operate in ambient temperatures above those indicated on the Luminaire nameplate.

Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

Substitution of components may impair suitability for Class I, Division 2, Class II Division I.

Do not disconnect equipment unless power has been switched off or the area is known to be
non-hazardous.

Do not let the power cord touch hot surfaces.

Do not mount near gas or electric heaters.

Equipment should not be mounted in locations and at heights where it will not be subjected to
tampering by unauthorized personnel.
www.LarsonElectronics.com
EPL-24-50LED
sales@larsonelectronics.com