GoFlight GF-P8 Manual

8 pushbutton/led panel

simulation experience more realistic and enjoyable.

The steps below will assist in ensuring the GF-P8 will be easy to install, configure and use. Following

these instructions will help to get you up in the "virtual skies" as quickly as possible.

NOTE If you own other GoFlight hardware and have already installed the most current

version of software on your system, you do not need to install the software again.

Simply skip the software installation steps in the instructions below.

Installing a GF-P8 Module

1. Get on line and go to www.goflightinc.com.

2. On the GoFlight home page click Support.

3. Click on "GF Config x.xx" to download the latest module drivers and configuration software.

4. Click "Run" or "Save" and follow the instruction to install the software. If the software installer detects

that GoFlight software is already installed on your system, it will prompt you to overwrite. Click the Yes

button to overwrite the existing version of GoFlight software. This is useful if you wish to keep the

configuration settings for other GoFlight modules installed on your system. However, you should first

make sure that the software you are overwriting is an older version and not a newer one.

5. If you are going to mount the GF-P8 module into a GF-AC rack, install the module in any desired

location in the rack using the two thumbscrews provided.

Virtual Pilot Operating Handbook

GF-P8 MANUAL

8 Pushbutton/LED Panel

Cockpit Control Module

Congratulations on your purchase of a

GoFlight

GF-P8

Panel module, part of the extensive

family of GoFlight GF-P8 Cockpit Control

System modules with a wide variety of

aircraft and is sure to make your flight

2012

GF-P8

8-Pushbutton/LED

Table of Contents

Do you have a question about the GF-P8 and is the answer not in the manual?

Page 1 5. If you are going to mount the GF-P8 module into a GF-AC rack, install the module in any desired location in the rack using the two thumbscrews provided.
Page 2 6. Plug the USB cable “B” connector end (square) into the connector on the back of the GF-P8 circuit board.
Page 3 This product is warranted to the original purchaser to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. During this warranty period, GoFlight Technologies, Inc. ® (“GoFlight”) will, at its option, repair or replace, at no charge, any component determined to be defective. The liability under this warranty is limited to the repair and/or replacement of the defect or defective part, and does not include shipping expenses.
Page 4 GF-P8 MANUAL 2012 Virtual Pilot Operating Handbook...