Advertisement
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Phillips screwdriver
Phillips screwdriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove the fanguard
1. Using a #2 Phillips screwdriver, remove the 3pcs M5 screws on the front side of fan module.
2. Remove the fanguard.
2. Remove the top cover
1. Using a #1 Phillips screwdriver, remove the 6pcs M2 screws between top cover and bottom cover.
2. Remove the top cover.
3. Remove the lightpipe and PCB
1. Using a #1 Phillips screwdriver, remove the 3pcs M2 screws attaching the PCB.
2. Disconnect fan and PCB cable connections.
3. Slide the lightpipe and PCB together off the bottom cover.
4. Remove the fan
1. Using a #2 Phillips screwdriver, remove two M5 screws attaching the fan.
2. Remove the fan.
5. Remove the cable holder
MF877-00
Template Revision A
HPE instructions for this template are available at
Tool Size (if
applicable)
MF877-01
#1
#2
Page 2
Advertisement
