Download Print this page

Sealey WS650.V2 Instruction Manual

Wheel skate 650kg capacity

Advertisement

Quick Links

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear
instruction
protective
manual
footwear
1. saFety
waRNiNg! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
Familiarise yourself with this product's application and limitations, as well as the specific warnings below relating to their use.
9
ensure the Wheel Skates are in sound condition and good working order. Take action for immediate repair or replacement of damaged
9
parts.
Use genuine parts only. The use of improper parts may be dangerous and will invalidate the warranty.
9
Wheel Skates should only be used in suitable, well lit areas.
9
wheel skates must be used in pairs at either the front or rear of the vehicle.
9
They must never be used diagonally.
9
Keep general area clean and tidy and free from obstructions.
9
Use Wheel Skates on level and solid ground, preferably concrete. Avoid tarmacadam as Wheel Skates may sink in.
9
maintain the Wheel Skates in good condition (use an authorised service agent).
9
ensure there are no passengers in the vehicle.
9
ensure the Wheel Skates are free to move and that there are no obstructions in the area of use.
9
When not in use store Wheel Skates in a safe, dry, childproof area.
9
DANGER: Use the Wheel Skates for manoeuvring or positioning of vehicles in interior situations. They are not designed for use
outdoors.
DO NOt start or drive the vehicle whilst it is raised on wheel skates.
8
DO NOt use the Wheel Skates for purposes other than that for which they are intended.
8
DO NOt allow untrained persons to operate the Wheel Skates.
8
DO NOt leave the vehicle unattended whilst it is raised on the Wheel Skates.
8
DO NOt operate the Wheel Skates when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOt get the Wheel Skates wet or use in damp or wet locations or areas where there is condensation.
8
DO NOt exceed the rated capacity of the Wheel Skates. Remember that the front of a vehicle is usually heavier than the rear.
8
DO NOt use the Wheel Skates to lift or support a vehicle in order to do work underneath it.
8
maintain correct balance and footing when moving vehicle. ensure the floor is not slippery and wear non-slip shoes.
9
ensure there are no obstructions beneath the vehicle when it is to be lowered.
9
ensure all non-essential persons keep a safe distance whilst the Wheel Skates are in use.
9
iMpORtaNt - We recommend that at least 2 persons are involved in manoeuvring the vehicle when supported on wheel skates. The
vehicle's weight provides a large amount of inertia which has to be overcome to get the vehicle moving and more importantly, stopped.
waRNiNg! The warnings, cautions and instructions covered in this manual cannot cover all possible conditions and situations that may
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. iNtRODuctiON
Steel chassis with PVC rollers and four Ø100mm nylon castors. Pedal operated hydraulic lifting action with safety locking pin when under load.
Rollers cradle vehicle's tyre and are capable of handling up to 270mm profile. Suitable for bodyshops, garages, showrooms or anywhere a disabled
vehicle needs moving on an even surface. Note: Skates sold as singles, but must be used in pairs.
3. speciFicatiON
model no ............................................................... WS650.V2
lifting capacity per skate .............................................. 650kg
Castor diameter ......................................................... 100mm
max. opening ................................................................ 550m
max. tyre profile ......................................................... 270mm
Weight ....................................................................17kg each
© Jack Sealey limited
wheel skate 650kg capacity
ws650.V2
model no:
Original Language Version
WS650.V2 | Issue:3 H,F) 20/07/18

Advertisement

loading

Summary of Contents for Sealey WS650.V2

  • Page 1 Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 The oil cylinder is a sealed unit and in principle should not be accessed. To top up the oil, remove oil plug on the ram. The oil level should be just below the oil plug hole. waRNiNg! Only a good quality hydraulic Jack oil, such as sealey hyDRaulic Jack Oil must be used, DO NOt use brake ‰...
  • Page 3 Guarantee is 12 months from purchase date, proof of which is required for any claim. sealey group, kempson way, suffolk Business park, Bury st edmunds, suffolk. ip32 7aR 01284 757500 01284 703534 sales@sealey.co.uk...