Table of Contents
Advertisement
1. Select the size of the ice cube by pressing the "Select" button (F). If the room
temperature is lower than 60F, it is recommended to select the small or me-
dium ice sign button in order to avoid ice sticking together.
2. Open the cover, remove the ice basket and pour water into tank. Keep water
level below the water MAX level mark.
3. Press "Power" button on the control panel to begin the ice making cycle.
4. The ice making cycle lasts approx. 6 to 15 minutes, depending on the size of
the ice cube selection and the ambient temperature. In a very wam room, ice-
making time may vary a lot.
5. While the icemaker is on, verify water level periodically. If water pump can't
inject water, the ice maker will stop automatically, and the "Add Water" indica-
tor (B) will be on.
6. If tank needs refilling, press "Power" button, fill water up to the MAX water level
mark and press "Power" button again to turn on the unit
7. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle
before restarting.
8. The ice maker automatically stops working when the ice basket is full and the
"Ice" indicator (C) will be on.
9. Change water in the water reservoir every 24 hours to ensure a reasonable
hygiene level.
10. If unit isn't in use, drain all water left in the tank.
•
Always unplug the ice maker before cleaning
•
Drain the water from the tank using the drain plug after each use or the water
will go stale
•
Take out the ice basket and wipe the inside of the tank with a soft cloth moistened
with a mild detergent solution.
•
Dry with kitchen towel
•
Clean the outside of the ice maker with a soft cloth
•
Do not use abrasive or strong chemical cleaners
•
NEVER IMMERSE THE UNIT IN WATER OR RUN UNDER THE TAP
SF32010N_IM.indd 5
HOW TO USE
CLEANING
5
25/09/2014 12:56
Advertisement
Table of Contents
