Advertisement
DO NOT use the heater without the grille fitted.
8
DO NOT use the heater out of doors. These heaters are designed for indoor use only.
8
DO NOT cover heater when in use, and do not obstruct the air inlet and outlet grilles.
8
DO NOT place heater too close to yourself or any object, allow the air to circulate freely.
8
DO NOT touch the outlet grille of the heater during and immediately after use as it will be hot.
8
Children of less than 3 years should be kept away unless continuously supervised.
9
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in
9
its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years to less than 8 shall not plug in, regulate and clean the appliance or
perform user maintenance.
This appliance can be used by children aged from 8 years and above and persons with physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
2. INTRODUCTION
P
Powder coated metal cabinet with two ruby halogen infrared elements and chemically polished reflectors for maximum heat emission. Controllable
power output by rocker switches on the side of the cabinet. Features easy-rolling castors (two locking). Suitable for a wide range of heating
including restorative applications. Supplied with power cable only.
3. SPECIFICATION
Model No. ..............................................................IRC153.V5
Power output (2 heat settings) ...................... 1500/3000 Watt
Size WxDxH ................................................560x490x885mm
Supply .....................................................................230V-16A
4. ASSEMBLY
4.1.
Attach the wheel sub-assemblies to the base of the heater using the bolts provided. Ensure the
lockable wheels are to the rear of the heater.
4.2.
Attach the handle to the top of the heater using the bolts provided, ensuring the shaped spacers
are fitted between the heater and the handle as shown.
4.3.
Remove the front grille by unscrewing the retaining screws.
4.4.
Extract the lamps from the shipping carton.
WARNING! Never touch lamp glass directly with fingers, only touch the ceramic ends or use a soft
‰
cloth, otherwise elements could be damaged.
4.5.
Carefully insert each lamp into the two push-in side fittings with a gentle pressure.
4.6.
Check the lamps are properly located.
4.7.
Reassemble front grille.
5. HEATER OPERATION
5.1.
Place the heater on a level floor in the area you require to heat. Allow a minimum of 2mtr between the heater and adjacent objects.
5.2.
Plug the heater into the mains supply and select the required output by using the two rocker switches on the side which switch the
elements on and off. Each lamp has an output of 1500W.
5.3.
To switch the unit off, select "0" on both the rocker switches and unplug from the mains. Allow the unit to cool before handling or storage.
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
‰
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
‰
wear to the lamps and reduce their working life.
5.4.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 25° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. If the unit does not turn on again when returned to the vertical, tip it
approximately 25° in the opposite direction until you hear the internal switch operate. As the heater switches on return it to the vertical
position.
WARNING! This heater is not equipped with a device to control the room temperature. DO NOT use this heater in small rooms when they
‰
are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
6. MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply, it is cool and on level
‰
ground.
DO NOT touch the element glass, even when cold.
8
DO NOT use the heater with out the grills fitted.
8
6.1.
To clean the reflector, remove the front grill by unscrewing the retaining screws and wipe the reflector with a clean dry cloth. DO NOT
use abrasives or solvents. The surface of the reflector is very soft and scratches may cause it to overheat. Replace the grille.
6.2.
To change the element remove the front grille by unscrewing the retaining screws.
6.2.1.
Ease the sprung sockets on the ends of the element back and pull the element forward so that it clears the socket, remove element.
WARNING! Never touch element glass directly with fingers, only touch the ceramic ends or use a soft cloth, to prevent damage.
‰
6.2.2.
Carefully insert the replacement lamp into the two push in side fittings with gentle pressure.
6.2.3.
Check the element is properly located, then replace front grill.
© Jack Sealey Limited
Original Language Version
IRC153.V5 | Issue 4 (1) 08/06/20
Advertisement
