Advertisement
Quick Links
PROPER USE GUIDELINES
Cumulative Trauma Disorder can result from the prolonged use of manually powered hand tools. NorComp hand
tools are intended for the occasional use and low volume applications.
30-28
26
AWG
AWG
HAND TOOL
960-702-170-000
1. INTRODUCTION
NorComp 960-702-170-000 Hand Tool Assembly
consists of Die Assembly and Hand Tool Frame.
CAUTION
Read these instructions thoroughly
before crimping any contacts.
NorComp, Inc.
Charlotte, NC
960-702-170-000
CONTACT
SIZE RANGE
(AWG)
30-26
This document is subject to change
Rev 3
WIRE
INSULATION DIAMETER
Max in. [mm]
0.040 [1.02]
Figure 1
2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, moving jaw, and moving handle. The
tool frame holds a die assembly with two crimping
chambers.
NOTE:
Use crimp section "A" for 30-28 AWG wire
Use crimp section "B" for 26 AWG wire
06/18/2020
Instruction Sheet
IS-960S
STRIP LENGTH
in. [mm]
0.094 [2.38]
Page 1 of 3
Date Printed 6/19/2020
Advertisement
Summary of Contents for NorComp 960-702-170-000
- Page 1 960-702-170-000 Instruction Sheet IS-960S PROPER USE GUIDELINES Cumulative Trauma Disorder can result from the prolonged use of manually powered hand tools. NorComp hand tools are intended for the occasional use and low volume applications. 30-28 CONTACT WIRE HAND TOOL SIZE RANGE...
- Page 2 960-702-170-000 Instruction Sheet IS-960S 3. CRIMPING PROCEDURE 5. Holding the wire in place, squeeze the tool handles together until ratchet releases. Allow tool handles to open and remove Strip the wire to the length indicated, taking care not crimped contact.
- Page 3 960-702-170-000 Instruction Sheet IS-960S 7. VISUAL INSPECTION The crimping dies should be inspected on a regular basis to ensure that they have not become worn or damaged. 1. Clean tool die area with solvent or brush. DO NOT immerse tool in cleaning solution 2.