BARRON TRACE-LITE FXA Series Installation Instructions

Advertisement

FXA 15-45W Series
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
20070168 REV 1 07/20

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRACE-LITE FXA Series and is the answer not in the manual?

Questions and answers

Summary of Contents for BARRON TRACE-LITE FXA Series

  • Page 1 FXA 15-45W Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
  • Page 2 FXA 15-45W Series Installation Instructions Knuckel Mount 1. Thread knuckle into the 1/2" NPS hole and secure it with 1/2" locknut (Figure 1). Note: Allow for proper line cord slack for adjusting the angle. 2. Make electrical connections, refer to Wiring section (Figure 4). 3.
  • Page 3 FXA 15-45W Series Installation Instructions Wiring Wire Connection - Standard Electrical connections should be made inside J-box. Line Cap all unused leads to prevent shorting. White Neutral Make electrical connections as follows: Ground Green/Yellow Green Black - Line White - Neutral Photocontrol Green/Yellow Green - Ground Note: This fixture auto adjusts for voltages from...

This manual is also suitable for:

Trace-lite fxa-15Trace-lite fxa-27Trace-lite fxa-45

Table of Contents