Advertisement
5.5.6.
Once the hole has been cut, back the cutting head back out of the hole and switch off the motor.
5.5.7.
Turn off the coolant tap.
5.5.8.
Turn off power supply before Removing the debris and swarf from the cutting head.
5.5.9.
Support the weight of the drill and turn off the magnet. Remove the cutting bit, undo the safety strap and replace drill in its case.
6. MAINTENANCE
WARNING! Disconnect from mains supply before performing any maintenance/cleaning.
‰
6.1.
Remove the cut 'plug' from the cutter each time it is used.
6.2.
Wipe down unit with lightly damped cloth after each use.
6.3.
Keep the tool clean.
6.4.
Store in a dry, childproof location in its case.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
MAG60230V
Issue 1
05/03/20
Advertisement
