Advertisement
1 Remove the diffusor. Place simultaneously 2 flat blade screwdrivers and pull up gently the
reflector.
2 Install the included plastic cover in to the unused hole and install the base plastic (with the
included mounting screws and plugs).
3 Always use in any case round mains cable, with external diameter of 6-9mm (H05RN-F type
2x1mm² or any other type, at least equal to it's mechanical and electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is important to
ensure the tightness isolation IP 65). Install the cable gland, pass the round cable thru and
tighten it all the way.
4 Place the battery's connector to the corresponding connector on the P.C.B. NOTE!! If you don't
need the yellow led's to light in normal operation, then remove the led jumper.
5 Connect the mains as shown in figure (connect the ground wire if required).
6 Install the included tie (if needed) to fasten securely the power cables.
7 Refit the reflector and fasten the two small screws (included).
8 Finaly place the diffusor by using the 4 included screws (tightening torque 1.2Nm).
1
N
L
5
Mains connection
8
Battery replacement.
It can be done only by a competent person and after the mains interruption.
1. Follow the step 1 of the installation procedure. Unfasten the 2 retaining screws and remove the
reflector (photo step 7).
2. Disconnect the connector and remove the old battery.
3. Connect the new battery with the same type (step 4 of the installation procedure) and place it
in the position of the old one.
4. Follow the step 7 and 8 of the installation procedure and power the device.
Page 2 from 2
INSTALLATION INSTRUCTIONS
2
6
NOTE!! After finishing the installation you must power the
luminaire at least for 24 hours for battery charging to perform the
named autonomy.
TEST procedure with extra care!!
9 Unfasten the mounting screws (step 8) and remove the diffusor.
When the luminaire is supplied by the mains, press on the marking
for TEST as shown in the picture below. Mount the diffusor by using
the 4 removed screws.
LED
JUMPER
3
7
923936006_23_011
4
Advertisement
