Wiring:
ODY-09-4/ODY-10-2
GND
PWR
DIM
SND
SEN-09-4
RED
BLACK
WHITE
Bare shield
Mounting:
The Series I gauge requires a rectangular hole 2-9/16" x 1-11/16". . It should be inserted into the opening
from the front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the
gauge is secure. Gauge depth to the back of the case is 1". Gauge depth including the mounting studs is 1-7/8".
Factory settings:
Sender type:
Lo warning point:
Hi warning point:
•
The pressure/boost gauge will operate and read correctly between the pressure range of 0psi - 100psi.
•
The gauge has a user adjustable low and high warning level. This can be set to indicate when the pressure is
too low or too high.
•
The gauge has a user adjustable warning level.
These senders have a 1/8" NPT fittings. The engine and sender threads should be cleaned before installation and
no tape or sealant should be used on the threads. The threads are self-sealing.
Contact Dakota Digital if you need to special order a metric bushing kit.
The sender must be Dakota Digital part SEN-09-4. Sending units from other manufacturers will cause incorrect
readings. If a sender is not connected properly, the display will show "EEE". If the SND terminal is shorted to
ground, the display will show "---".
ODY-09-4 BOOST GAUGE rev. C
ODY-10-2 PRESSURE GAUGE rev. C
SEN-09-4 SENSOR
-
Connect to a main ground location.
-
connect to 12 volt power. (An accessory circuit will work for this.)
-
connect to the tail light circuit.
-
connect to the SEN-09-4 white wire.
-
connect to accessory power
-
connect to gauge ground
-
connect to the gauge SND terminal
-
connect to gauge ground
SEN-09-4
0-60 psi.
9-99 psi.
Series II
MAN# 650199