Regular Maintenance Procedures - Master Spas MP Force Owner's Manual

REGULAR MAINTENANCE PROCEDURES

WATCH HOW-TO VIDEOS:
NOTE: These maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
DRAINING YOUR SWIM SPA
Due to the physical size of the swim spa, we recommend draining your swim spa with a
submersible sump pump. Draining your swim spa with a conventional spa drain is not a reasonable
option. When draining the Momentum 80 swim spa always drain the water from the spa side
before draining the swim side. Your swim spa requires periodic draining and cleaning to ensure
a safe, healthy environment. It is recommended that you clean your swim spa at least every 180
days. Heavy bather load will require cleaning it more often.
STEPS FOR USING A SUMP PUMP*
1. Turn off power to your swim spa at the GFCI breaker.
2. Carefully lower submersible pump with hose connected into the lowest point of swim spa,
taking care not scratch or gouge your spa swim shell (for Momentum model with the clear
divider between the spa end and swim end, always pump out the spa side first and then the
swim side).
3. Run the discharge end of the hose from your submersible pump to a desired location several
feet away from your swim spa, where the water will drain away from foundation that the swim
spa is resting on.
4. Plug in/turn on your submersible pump.
5. Turn off/disconnect your submersible pump once it is no longer able to suck up any further
water (indicated by a suctioning sound and water no longer coming out of the drainage hose).
If you plan to fully wipe down and clean your entire swim spa shell, a shop vac can be used to
remove the remaining small pockets of water in the swim spa.
* Sump Pump is not provided with spa.
SWIM SPA SURFACE CARE
• Clean the spa shell, jets and other controls with a soft cloth and spa shell cleaner to help remove
residue and buildup on the shell surface. For mineral based buildup, white vinegar or mild scale
remover product may be necessary to use with a soft cloth for removal. Consult with your local
Master Spas dealer for proper swim spa cleaning products.
• Rinse the cleaned surfaces with fresh water from your garden hose and wipe with soft cloth as
doing so will help remove residual cleaning agents (as some may cause foaming to occur in the
water once refilled).
• Always use an approved insulating swim spa cover by Master Spas to cover your swim spa
when not in use, especially in outdoor installations where the swim spa is exposed to weather
conditions and sun. Constant, prolonged exposure and use of unapproved or non-insulating
swim spa cover can result in damage to swim spa surface which would not be warranted.
REFILL YOUR SWIM SPA
• When filling the Momentum swim spa always fill the swim side of the unit before filling the spa
side.
• Refer to the Water Maintenance Start-Up section for specific instructions.
DO NOT DIVE. DO NOT DIVE.
masterspas.com/video-tutorials
100 25