Us And Canada - JBL E45BT Quick Start Manual

US AND CANADA
FCC AND IC STATEMENT:
This device complies with Part 15 of the FCC rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
CAN ICES-3(8)/NM8-3(8)
FCC/IC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC/IC RSS-1 02 radiation exposure limits set
forth for an uncontrolled environment.
DECLARATION DE LA FCC ET D'IC
Le present appareil est conforme aux CNR d'lndustrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisee aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi,
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
DECLARATION DE LA FCC ET D'IC SUR L'EXPOSITION AUX RADIATIONS
Cet appareil est conforme
a
Ia norme RSS 1 02 de Ia FCC/IC relative aux limites
d'exposition aux radiations dans un environnement non controle.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limrts for a Class 8
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
~this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio!TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.