Table of Contents
Advertisement
Ensure BIOS settings for Windows NT servers have the "Non PnP
OS" selected.
If a Blue Screen occurs during NT startup and NT cannot be
started, remove all devices from the system and reboot.
Try a process of elimination to run the system in a single
minimal system configuration, such as by inserting each
device into the system and rebooting. Usually starting with
the VGA/AGP card if not on board.
"4-ReelTime: board was not found"
Make sure the board or boards are securely seated in the
PCI bus.
"ReelTime 4: Failed to allocate mem"
Be sure and verify default performance settings in VccReg.
Verify all memory is detected by server on start up or by
right clicking on My Computer and reviewing General.
"ReelTime 4: HARDWARE ERROR"
Inspect the decoder board for damage. Also review the
voltage of the server's motherboard. The 3.3v setting is the
default jumper for VCC decoder boards and may need to be
changed to 5v as required. Refer to jumper settings for the
board being used.
Advertisement
Table of Contents
