Needle Threader - Janome 4300QDC Instruction Book

z
w
x c
x
e
r
v
b
q
e
y
c
t
t
u

Needle Threader

CAUTION:
Turn off the power switch when using the needle
threader.
NOTE:
The needle threader can be used with a 11 to 1
needle or a blue tip needle. Thread sizes 50 to 90
are recommended.
The needle threader cannot be used for a twin
needle.
z Press the needle up/down button q to raise the
needle to its highest position.
Turn the power switch off.
Pull down the needle threader knob as far as it will
go. The hook comes out through the needle eye from
behind.
q Needle up/down button
w Needle threader knob
e Hook
x Draw the thread from guide (a) r to guide (b) t and
under the hook e.
e Hook
r Guide (a)
t Guide (b)
c Draw the thread up along the right side of guide (b) t
and slip the thread in between guide (b) and the holder
plate y .
t Guide (b)
y
Holder plate
v Raise the needle threader knob in the direction of the
arrow, drawing the thread loop through the needle.
u
Thread loop
b Pull the thread through the needle eye.
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
22