Table of Contents
Advertisement
LED Behavior
The following table describes the Orbi LED behavior.
Table 1. LED descriptions
LED
Power
Router ring
Satellite ring
Router ring and satellite
ring during sync
Orbi High-Performance AC3000 Tri-band WiFi System
LED behavior
The Power LED is located above the Power On/Off button on the rear panel.
•
Solid green.Power is on.
•
Solid amber. The router or satellite is rebooting.
•
Blinking amber. Resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
The ring LED is located on the top.
•
Solid white. The router is booting.
•
Off. The router finished booting and is working normally.
•
Blinking white. The router is resetting to factory settings.
•
Blinking amber. The router cannot connect to the Internet. See
Access the Internet
•
Blinking blue and magenta. The Internet connection is blocked because
you set up Internet traffic metering and reached the maximum allowed
amount of Internet traffic.
The ring LED is located on the top.
•
Solid white. The satellite is booting.
•
Off. The satellite finished booting and is working normally.
•
Blue for 10 seconds. The connection between the router and the satellite
is good.
•
Amber for 10 seconds. The connection between the router and the
satellite is fair.
•
Blinking magenta. The satellite is not connected to the router.
•
Magenta for 10 seconds. The satellite cannot get an IP address from the
router.
The ring LEDs are located on the top.
•
Blinking white. The Sync button was pressed.
•
Blue for 3 seconds.The sync between the router and satellite succeeded.
•
Magenta for 3 seconds. The router and satellite failed to sync. See
Router and Satellite Do Not Sync
Overview
on page 100.
on page 99.
8
Cannot
The
Advertisement
Table of Contents
