Table of Contents
Advertisement
Quick Links
**T
HIS MODEL IS NOT FIELD CONVERITBLE FOR
FROM THE
**T
HIS MODEL IS NOT FIELD CONVERITBLE FOR
THE
I
F YOU HAVE QUESTIONS
I
NSTALLATION
P
ROFESSIONAL
36" G
C
AS
OOKTOP WITH
36" N
ATURAL
*TN037-7
F
ACTORY SET FOR
36" LP/P
ROPANE
*PN037-7
F
ACTORY SET FOR
,
800-251-7224, 8
CALL
,
.F
WEBSITE
WWW
I
NSTRUCTIONS
C
M
OOKTOP
ODELS
S
B
EALED
URNERS
G
M
AS
ODEL
LP/P
ROPANE GAS
N
LP/P
ATURAL OR
G
M
AS
ODEL
N
. I
ATURAL GAS
N
LP/P
ATURAL OR
ROPANE
5
E
AM TO
PM
S
R
.
IVE
TAR
ANGE
COM
**
. I
T MUST BE ORDERED
.**
ROPANE
T MUST BE ORDERED FROM
.**
T
,
ASTERN
IME
OR VISIT OUR
.
Advertisement
Table of Contents
Related Manuals for FiveStar TTN037-7
Summary of Contents for FiveStar TTN037-7
- Page 1 NSTALLATION 36” G HIS MODEL IS NOT FIELD CONVERITBLE FOR FROM THE ACTORY SET FOR HIS MODEL IS NOT FIELD CONVERITBLE FOR ACTORY SET FOR F YOU HAVE QUESTIONS CALL WEBSITE NSTRUCTIONS ROFESSIONAL OOKTOP ODELS OOKTOP WITH EALED URNERS 36” N ATURAL ODEL *TN037-7...
-
Page 2: Before You Begin
Consumer. • Note to Consumer Keep these instructions for future reference. • FiveStar recommends this product be installed by a licensed professional. • Product failure due to improper installation is not covered under the Warranty. WARNING: This appliance must be properly grounded. - Page 3 NSTALLATION NSTRUCTIONS Please read these instructions before attempting to install this cooktop. Inspection and Unpacking Check the cooktop carton for visible damage. If there is damage or even creases in the carton, contact the carrier, request an inspection and file the appropriate freight claim.
-
Page 4: Remove Packaging
STEP 1 REMOVE PACKAGING Before moving the cooktop indoors: Remove outer carton and packing material from the shipping base. The cooktop is now ready for removal from the wooden base. STEP 2 To simplify handling and to reduce the weight of the cooktop: Remove the grates. -
Page 5: Electric Connection
STEP 4 ELECTRIC CONNECTION This cooktop must be supplied with 120 volt, 60 Hz. and connected to an individual, properly grounded branch circuit protected by a 5 amp circuit breaker or time delay fuse. The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong grounding wall receptacle to minimize the possibility of shock hazard from this... - Page 6 When using test pressures of ½ psig or less to test the gas supply system, simply isolate the range from the gas supply system by closing the individual shut- off valve. *Teflon: Registered trademark of Dupont.
-
Page 7: Griddle Operation
STEP 6 SURFACE BURNER OPERATION SEALED BURNERS Assemble top burners as shown. Check to be sure that burner caps are securely seated. Burner cap must completely engage into burner base to ensure proper assembly. • Check for proper ignition: − Push in one control knob and turn 45° counter clock- wise to LITE position. - Page 8 STEP 8 CHECKLIST FOR SEALED BURNER INSTALLATION MAKE SURE ALL CONTROLS ARE IN THE “OFF” POSITION. Gas supply is “on” Electric power is “on” Check for proper seating of burner caps into burner base. Burner grates in position Surface burner ignition test Griddle/Grill burner ignition test Griddle/Grill assembly in position MAKE SURE ALL CONTROLS ARE LEFT IN THE “OFF”...