Operation - Stanley SIG 3200 Original Instructions Manual

G
B
(for example an earthing rod).
7.4 Topping up fuel (Fig.1)
WARNING
Switch off and ensure you are in a well ventilated area.
Unscrew the tank cover (Item 2) and add enough
unleaded gasoline using a filler neck.
Ensure that you do not overfill the tank and spill petrol.
(If you do spill, wipe up the excess amount and wait until
the vapors have evaporated – danger of ignition.) Screw
the tank cover back on.
7.5 Topping up oil (Figs. 3 , 5 and 6)
WARNING
Switch off and ensure you are in a well ventilated area.
Open the oil filler screw (Item F) and add approximately
0,6 l of engine oil (15W40 above 0
using the supplied oil filler jug (Item 19 and 20) or until
the top fill mark on the oil dipstick (Item D) is reached.
Important:
Do not screw in the oil dipstick to check the oil level –
only insert it as far as the thread. Close the oil filler
opening and remount the engine cover.
Important! You must fill up with engine oil and fuel
before you can start the engine.

8. Operation

Check the fuel level and top it up if necessary.
•
Make sure that the generator has sufficient ventilation.
•
Make sure that the ignition cable is secured to the
•
spark plug.
Inspect the immediate vicinity of the generator.
•
Disconnect any electrical equipment which may
•
already be connected to the generator.
8.1 Starting the engine (Figs. 1 , 2)
Important: Do not use any chemical starting agents
such as highly volatile fuels or similar.
•
•
•
•
the handle forcefully. If the engine does not start, pull
the handle again. Important:
Always pull the starter cable slowly until you feel the
initial resistance before you then pull it quickly to start
the engine. Do not allow the starter cable to whip back
of its own accord.
•
30 seconds after the engine has started.
0 0
C, 5W30 below 0 C))
8.2 Economy mode
Economy switch (Item 9) in the "I" On position:
The engine speed is regulated in accordance with
minimum power requirements and the generator runs
quietly and efficiently.
Economy switch (Item 9) in the "O" Off position:
The generator runs at maximum speed.
8.3 Connecting consumers to the generator (Fig. 2)
•
to the socket (Item 10). Important: This socket is allowed
to be exposed to a continuous (S1) load of 2000 W and
temporarily (S2) for a maximum of 2 min to a load of
2200 W.
•
mains system, since this may damage the generator.
Note: Some using electrical appliances here but not
through out manual (power jigsaws, drills, etc.) may
have a higher level of power consumption when used in
difficult conditions.
8.4 Overload cut-out (Fig. 2)
10
Open the petrol cock (5) by turning it down.
Move the ON/OFF switch (Item 7) to the "I" position.
Pull the choke lever (Item 6).
Start the engine with the starter cord (Item 4) by pulling
Push the choke lever (Item 6) back approximately 15 to
Connect the 230 V~ electrical appliances to be powered
Do not connect the generator to the household