Cleaning; Cleaning Under The Mower; Waste Disposal; Storage - Toro 74291 Operator's Manual

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.

Storage

1. Disengage the power take off (PTO), set the parking
brake and turn the ignition key to off. Remove spark
plug wire. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff
from the outside of the engine's cylinder head fins
and blower housing.
Important: You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use of
water, especially near the control panel, engine,
hydraulic pumps and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner in Engine Maintenance , page 27.
4. Grease and oil the machine; refer to Greasing and
Lubrication in Lubrication , page 25.
5. Change the crankcase oil; refer to Servicing the
Engine Oil in Engine Maintenance , page 27.
6. Change the hydraulic filter; refer to Servicing the
Hydraulic System in Hydraulic System Maintenance ,
page 39.
7. Check the tire pressure; refer to Checking the Tire
Pressure in Drive System Maintenance , page 33.
8. Charge the battery; refer to Servicing the Battery in
Electrical System Maintenance , page 31.
9. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the PTO engaged
and the engine at high idle for 2 to 5 minutes after
washing.
10. Check the condition of the blades. Refer to Servicing
the Cutting Blades.
11. Prepare the machine for storage when non-use
occurs over 30 days. Prepare machine for storage
as follows.
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
stabilizer manufacture. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and
used at all times.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
48