Panasonic TX-P42ST50E Operating Instructions Manual page 19

Changing 2D - 3D mode
You can easily change the viewing mode between 2D and 3D using the 3D button.
Select the mode
3D Mode Selection
2D 3D
3D
2D
[3D] / [2D] / [2D 3D]:
Displays the appropriate image that you desire without selecting 3D format.
●
This mode may not work properly depending on the source image format. In this case, select the appropriate 3D
format manually.
■
To change 3D format manually
When the image is not changed properly using [3D], [2D] or [2D 3D] mode, use this manual setting.
During the above operation
(red)
Table of images that can be seen for each [3D Mode Selection (Manual)] and the source image format
If the picture appears to be abnormal, refer to the table below to choose the correct 3D mode.
Source image
format
Frame Sequential
Side by Side (Full)
Side by Side
Top and Bottom
Normal format (2D)
∗ 1: When selecting [Frame Sequential - 2D], [Side by Side - 2D] or [Top and Bottom - 2D], the images will be displayed
without 3D effect.
●
Depending on the player or broadcasts, the image may be different from the above illustrations.
Select the mode
3D Mode Selection (Manual)
Original
Frame Sequential - 3D
Frame Sequential - 2D
Side by Side - 3D
Side by Side - 2D
Top and Bottom - 3D
Top and Bottom - 2D
2D 3D
[Frame
[Original]
Sequential - 3D]
Normal 3D ∗
●
Items of [3D Mode Selection] vary
select
depending on the condition.
set
[3D Mode Selection]
[Side by Side
- 3D] Bottom - 3D]
1
Normal 3D ∗
1
Normal 3D ∗
1
select
set
[Top and
[2D 3D]
Normal 3D ∗
1
Normal 3D
19