Table of Contents
Advertisement
Maintenance
1
2
7
3
Figure 42
1. Neutral lock position
2. Clevis pin in slot
3. Nut
4. Bolt
Adjusting Hydraulic Pump Neutral
Note:
Adjust handle neutral first. That has to
be correct before the following
adjustment can be made.
POTENTIAL HAZARD
Mechanical or hydraulic jacks may not
support machine.
WHAT CAN HAPPEN
Weight of machine can cause hydraulic
jacks to fail and cause an injury.
HOW TO AVOID THE HAZARD
Use jack stands when supporting machine.
Do not use hydraulic jacks.
1.
This adjustment must be made with drive wheels
turning. First raise the frame and block up so
drive wheels can rotate freely.
56
4
1
6
5
3
m–3800
5. Pump rod
6. Double nuts
7. Jam Nut
POTENTIAL HAZARD
Engine must be running so motion control
adjustment can be performed.
WHAT CAN HAPPEN
Contact with moving parts or hot surfaces
may cause personal injury.
HOW TO AVOID THE HAZARD
Keep hands, feet, face, clothing and other
body parts away from rotating parts,
muffler and other hot surfaces.
2.
Slide seat forward, disconnect prop rod and tilt
seat fully forward.
3.
Disconnect electrical connector from the seat
safety switch. Temporarily install a jumper wire
across terminals in the wiring harness connector.
4.
Loosen locknut at ball joint on pump control rod
(Fig. 42).
Note:
The front nut of each rod has left–hand
threads.
5.
Start engine, open throttle 1/2 way and release
parking brake. Refer to Starting and Stopping
the Engine, page 26.
6.
Adjust pump rod length by rotating double nuts
on rod, in the appropriate direction, until wheel
is still or slightly creeps in reverse (Fig. 42).
7.
Move motion control lever forward and reverse,
then back to neutral. Wheel must stop turning or
slightly creep in reverse.
Note:
Motion control lever must be in neutral
while making any adjustments.
8.
Open throttle to fast. Make sure wheel remains
stopped or slightly creeps in reverse, re-adjust if
necessary.
Advertisement
Table of Contents
