Toro 30193 Operator's Manual page 17

Connect Wire Harness
1. Route wire harness inside of frame, along left
handle and over throttle cable. Compress wire
harness covering and press into lower and upper
holes in rear of control panel (Fig. 3).
2. Thread harness up through rear tube of traction
handle (Fig. 3).
Figure 3
1. Wire harness
2. Control panel
3. Insert terminals into plastic plug until the clips
snap into position (Fig. 4). If they do not snap
turn around.
4. Push plug onto switch so latches interlock
(Fig. 4).
5. Secure wire harness and throttle cable to left
handle, away from PTO lever, with wire tie
(Fig. 3).
Figure 4
1. Terminal
2. Clip
m–4211
3. Tube
4. Wire tie
m–3782
3. Plastic plug
4. Switch
Install Traction Control Rods
1. Thread trunnions equal distance onto each
control rod. For a starting point thread on
approximately 2 in. (51 mm) (Fig. 5).
2. With trunnion rod up, slide clevis pins through
rod fittings and mounting holes in idler brackets
(from outside) (Fig. 5). Secure with 1/4" (6 mm)
washers and hairpin cotters (Fig. 5).
Figure 5
1. Control rod
2. Trunnion
3. Idler bracket
Assembly
m–3785
4. Clevis pin
5. Washer 1/4" (6 mm)
6. Hairpin cotter
15