Adjusting The Parking Brake Interlock Switch - Toro 30242 Operator's Manual

4-wheel drive traction unit
Hide thumbs Also See for 30242:
Table of Contents

Advertisement

engine off. Depress only the right brake pedal
and engage the parking brake.
2.
Jack up the left front side of the machine until the
tire is off the shop floor. Support the machine
with jack stands to prevent it from falling
accidentally.
3.
Lift the seat. Visually inspect the traction linkage
for a possible binding condition. Correct it, if
necessary, and check machine operation. If the
condition still exists, repeat steps 1 and 2 and go
to step 4.
4.
Loosen the two locknuts securing the pump plate
so the plate can move freely (Fig. 33).
5.
Start the engine and rotate pump plate (Fig. 33)
in either direction until the wheel ceases rotation.
2
Figure 33
1. Pump plate
2. Locknut
6.
Stop the engine and tighten the locknuts to secure
the pump plate (Fig. 33).
7.
Start the engine and check adjustment. Repeat
the adjustment, if necessary.
8.
Stop the engine and release the right brake.
Remove the jack stands and lower the machine to
the shop floor. Test drive the machine to be sure
it doesn't creep.
Adjusting the Parking Brake
Interlock Switch
1.
Turn the engine off and remove the ignition key.
Do not engage the parking brake.
2.
Remove the (6) screws securing the front steering
tower cover to frame and remove the cover
(Fig. 34).
1. Front steering tower cover
2. Parking brake lever/rod
3.
Disconnect the switch pigtail connector from the
wire harness (Fig. 35).
4.
Connect a continuity tester or ohmmeter to the
switch harness connector.
1
1. Parking brake interlock switch
2. Parking brake rod collar
3. Wire harness connector
5.
Loosen the set screw securing the collar to the
parking brake rod (Fig. 35).
6.
Slowly move the collar on the rod until it is
aligned with cross hairs on the switch label
(Fig. 35). Tighten the collar set screw.
7.
With the parking brake disengaged, the switch
circuit should have continuity. If there is no
continuity, move the collar slightly up the rod
until there is continuity and tighten the collar set
33
1
Figure 34
3
2
Figure 35
2
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 228-d

Table of Contents