Panasonic TX-L32ET5Y Operating Instructions Manual page 13

4. After the access point setting is finished, perform the connection test
6
Connection Test
Check wireless network connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection.
5. Go to the next step
(Press twice)
[WPS(Push button)]
1. Press the WPS button on the access point until the light flashes
2. Connect the TV with the access point
WPS(Push button)
1) Please press the 'WPS' button on the wireless
access point until its light flashes.
2) When the light is flashing select 'Connect' on
TV.
If you are unsure, please check the instruction
manual of the wireless access point.
Connect
3. After the access point setting is finished, perform the connection test
Connection Test
Check wireless network connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection.
4. Go to the next step
(Press twice)
Select [Home]
7
Select [Home] viewing environment to use in your home environment.
Please select your viewing environment.
Home
[Shop] viewing environment (for shop display only)
[Shop] viewing environment is the demonstration mode to explain main features of this TV.
Select [Home] viewing environment to use in your home environment.
You can return to viewing environment selection screen at the stage of Shop confirmation screen.
1
Return to viewing environment
selection screen
Shop
You have selected shop mode
To change viewing environment later on, you will need to initialise all settings by accessing Shipping
Condition.
Auto Setup is now complete and your TV is ready for viewing.
If tuning has failed, check the connection of the RF cable, and then, follow the on-screen instructions.
Note
To retune all channels [Auto Setup] in the Setup Menu
To add the available TV mode later
To initialise all settings
Ensure that your access point supports WPS for this setup.
WPS: Wi-Fi Protected Setup™
If the connection has failed, check the settings and positions of your
access point. And then, follow the on-screen instructions.
Shop
[Add TV Signal] in the Setup Menu
[Shipping Condition] in the Setup Menu
: succeeded
The test is successful and the TV is connected to the
network.
: failed
Check the settings and connections. And then select
[Retry].
To set manually, select [Manual] and set each item.
: succeeded
The test is successful and the TV is connected to the
network.
: failed
Check the settings and connections. And then select
[Retry].
To set manually, select [Manual] and set each item.
select
set
2
Select [Home]
Please select your viewing environment.
Home
select
Shop
set
13