Philips PET704 Service Manual page 3

1.0 TECHNICAL SPECIFICATION
Factory Service Mode (FSM)
Procedure to check the software version of
your portable DVD Player
1. Open the DVD door at power off status
2. Press [POWER] + [SETUP] button on the main set
at the same time
3. Release the buttons until PHILIPS LOGO is
displayed
4. Figure#1 will be displayed and it will show the
software version of the set
Figure#1 – MAIN FSM MENU
Procedure to upgrade the software of your
portable DVD Portable
For the best performance of your DVD Portable.
Check www.philips.com/support for latest
software upgrades available.
1. Download the latest software from the Philips
support site
2. Unzip the files and then burn it into a CD-ROM to
make a disc for upgrade
Hint: Must be make sure folder named with
"DVD_FIRM"!
3. Power on the Portable DVD Player with AC/DC
adaptor
4. Play CD-ROM for firmware upgrade
5. Press [OK] when Figure#2 is displayed
Figure#2 – Flash upgrade
6. Figure#3 will be displayed and upgrade will start
Figure#3 – Updating
Warning: Do not unplug the AC adaptor during
firmware upgrade to prevent flash corrupt of the
set!!
7. Once upgrade is completed, the player is reset
automatically and the upgrade screen is displayed
again.
8. Open the DVD door to remove the disc
Procedure to change region code of your
portable DVD player
1.
Open the DVD door at power off status
2.
Press [POWER] + [MENU] button on the main set
at the same time
3.
Release the buttons until PHILIPS LOGO is
displayed
4.
Figure#4 will be displayed
Figure#4 – Region Code MENU
Press Number Key button by remote control
5.
to select the region code
Refer below table for your region code setting
6.
Confidential: Region code "0" can be used for all
region.
[OK] to save your setting
7. Press
exit
and power off to