VGA and power cord jack of the LCD monitor 5. Dual Mode: If your system is Dual signal model, then connect the DVI cable to the DVI port on LCD Monitor. 6. Use Audio cable to connect “Audio in” jack on LCD Monitor. PRESTIGIO P372...
Page 4
While attaching up the rear stand cover, the “Clicking Sound” tells that rear stand cover is hooked up properly) Or Attachint up the stand cover then VGA cable Power cord and Audio cable jack of the LCD monitor ? For Analog only For Dual Mode PRESTIGIO P372...
Page 5
For added protection, it is recommended to use a Surge Protection device plugged between the AC Adapter and the electrical wall outlet to prevent the effects of sudden current variations from reaching the LCD Monitor. Sudden peaks of electricity may cause damage to the Monitor. PRESTIGIO P372...
Hot Key Power Switch Power ON/OFF the monitor Green – Normal operation Amber – Power Management > Indicated the Increasing movement To select the feature Hot Key Auto: Automatically adjust clock, phase and image position Exit : Return PRESTIGIO P372...
* Press the < or > key to select the feature which needs to be adjusted or press the OK again to exit the Main Menu * Press Reset to set all user settings return to the factory preset value. PRESTIGIO P372...
Page 8
* Then, press the > or the < key again, the Un-Mute function will be activated, and the indicated image will pop up right after. * Press the OK to exit the Muting Function or the dialog will disappear automatically in a few seconds. PRESTIGIO P372...
Page 9
At the same time, the Clock and Phase feature will be disabled in Sub Menu as well, and the color of both indicators’ color Clock and Phase will be also indicated in 2 gray colors with different thickness as below. PRESTIGIO P372...
Page 10
Note: Press Menu button to enter the selection state .Next press < or > key to adjust the selection to the desired value on selected item. Press OK button to exit adjusted state or return to the main OSD menu. PRESTIGIO P372...
Power LED Power Recovery Time H-sync V-sync Consumption Normal Green <36W — Stand By No Display Amber < 1W 3 sec Suspend No Display Amber < 1W 3 sec Active Off No Display Amber < 1W 3 sec PRESTIGIO P372...
Display is too dark or too bright. If the video output level of the computer is within the spec. e) Display is not in the center. If the signal timing of the computer is within the spec. PRESTIGIO P372...
It shows that compliance with both Canadian and US requirements for classified products has been met. follows :Safety:UL60950-1,CAN/CSA –C22.2 N0 60950-1-03 TUV MARKING DECLARATION OF CONFORMITY The product complies with the requirements of related Germany standard As follows :Safety:EN60950-1, IEC60950-1 PRESTIGIO P372...
It may cause fire, electric shock or damage when operating the monitor with foreign objects inside. DO NOT USE THE MONITOR NEAR WATER Operating the monitor in close proximity to water where the water may be spilt or splashed onto the monitor may cause fire or electric shock. PRESTIGIO P372...
Do not attempt to replace it yourself. * If you need to return your unit for service and the original packaging was discarded, please contact your dealer or the nearest service center for advice or replacement of packaging. PRESTIGIO P372...
Page 16
Cabinet * Remove dirt with a lightly moistened cloth and a mild solvent detergent. Then wipe the cabinet with a soft dry cloth. * Periodic cleaning with a soft dry cloth is recommended. PRESTIGIO P372...