Download Print this page

Status Pane - junger C8492 Manual

Digital audio modular processing system 4/8/16 channels dsp with sdi & system-bus i/o

Advertisement

digital audio
modular
processing system
4/8/16 channels DSP with SDI & system-bus I/O

STATUS PANE

The status area is quite big for the C8492 so you may face difficulties when displaying it on lower
resolution displays. You may shrink it by pressing on the little "fly foot print":
Now some information are suppressed and you are able to see the
most relevant status information without the need to put the browser
into full screen mode.
C8000
C8492 DEVICE 00
- Given name of the module (may be changed on the
DEVICE pane). It will be default set during initialization to module type
amended by the word
DEVICE
that moment.
System name of the module and short description.
DSP Preset
Routing/SDI Preset
Failover/Upmix Preset
SDI Status
Soft LED:
green
yellow
red
SYNC MASTER
BYPASS
grey / red
DSP1
DSP2
SDI
SDI-Relay
Bit Transparent
Ch 01/02 ... 07/08
Ch 09/10 ... 15/16
Failover/Upmix
A
B
Upmix 1
C
D
Upmix 2
Bus/Input Status
Processing Status
Metadata Status
SDI De-Embedder Status
Temperature
Metering
C8492(B)
and the CAN address
00
Name of the actual loaded preset.
Name of the actual loaded preset.
Name of the actual loaded preset.
[SD / HD / 3G / TG / UNLOCKED]
if Rx locked.
if Rx locked + async audio
if Rx unlocked + Always ON + Last Valid
if Rx unlocked + TG=OFF or TG=AUTO
if TG=Always ON + None
appears if the SW1 #5 is set to ON.
turns red if a bypass is activated.
turns red if the DSP bypass check box is
enabled, if the SDI bypass or the
fail over relay is activated.
shows the bit transparent status of the
respective DSP channel pairs.
turns green if a function is active.
Error status of the bus inputs (see
ROUTING).
turns green if observation of processing
status is enabled. Turns red if processing
status is bad (see DSP1-A Processing
Status Enable).
turns green if valid metadata are detected.
Turns red if metadata are corrupted.
shows status of the de-embedder
Module temperature measured on the
carrier board.
clicking on that symbol will open the applet
to display meter bar graphs (see page 24
for an example) channels.
the module had at
page 6/30

Advertisement

loading

This manual is also suitable for:

C8492b