Operating Program - Skyrc D400 Instruction Manual

Here is the detailed procedure to make the charger work. All the screens and operations
will take Li-Po BALANCE CHARGE program for example,
Note: We will explain one channel as the operating procedure
of Channel 1 and Channel 2 is identical.
1. Connection
1). Connecting to power source
There are two kinds of inputs for SKYRC D400, DC 11-18V and AC 100-240V.
A. Operating in AC mode
SKYRC D400 comes with built in switching power supply. You can connect the AC
power cord directly to the main AC socket. (100-240V AC).
Note: The charging power in AC mode is 400W totally for Channel 1 and Channel 2.
In AC mode, it supports Power Distribution. The total power for Channel 1 and
Channel 2 is 400W. You could set the Max Power for one channel (Take Channel 1
for example)as following,
M a x P o w e r S e t
And the other channel (Channel 2) will take the rest power automatically (For example, if
you set channel 1 as 300W, the channel 2 will be 100W).
NOTE1: If Channel 1 and Channel 2 are both charging, you can't change the power
distribution.
NOTE2:
If Channel 1 is charging, you can change power of Channel 2 and Channel 1
will take the rest power automatically.
B. Operating in DC mode
Please connect SKYRC D400 with AC/DC power supply by supplied DC input cable. Also
you could use terminal clips with DC connectors, for attaching directly to 12V car
batteries. It is critically important that you use either a fully charged 13.8V car battery or a
high quality AC/DC power supply in the range of 11-18V DC output with minimum power
500W or higher to insure reliable performance.
D400
3 0 0 W

Operating Program

M a x P o w e r S e t
1 0 0 W
13 ·