Table of Contents
Advertisement
There are 2 small notches on front of log
that fit onto front tabs and 2 small notches
on back that fit over back tabs.
2. Place front log onto grate. Log is notched
to sit over grate (see Figure 23).
Front Log
Grate
Figure 23 - Installing Front Log (#2)
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting
the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
18
INSTALLATION
Continued
3. Place crossover log onto recesses on
main log and front log (see Figure 24).
Note: Nontextured end of crossover log
faces back of firebox and will not be seen
from front of log set.
4. Add lava rock around base of heater if
desired. Do not place any lava rock on
logs or burner.
Crossover
Log
Figure 24 - Installing Crossover Log (#3)
OPERATION
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
• Immediately call your gas supplier
• If you cannot reach your gas supplier,
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a quali-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
www.desatech.com
not use any phone in your building.
from a neighbor's phone. Follow the
gas supplier's instructions.
call the fire department.
Recesses
on Logs
122260-01E
Advertisement
Table of Contents
