Rheem R801TA050314MSA Installation Instructions Manual page 12

DUCTING
FIGURE 5
LIFT UP, PULL OUT
1. REMOVE 2 SCREWS, LIFT BASE UP, SLIDE FORWARD TO REMOVE.
2. INSTALLATION IS REVERSE OF REMOVAL.
** VERIFY REAR FLANGE IS SEALED PROPERLY AS SHOWN IN DETAIL.
FIGURE 6
12
NOTE: NOTE:
SOLID BASE PLATE PROVIDED WITH (-)801P
SOLID BASE PLATE PROVIDED WITH (-)801T
MODELS ONLY.
MODELS ONLY.
WHEN SOLID BASE PLATE IS USED . TAPE
WHEN SOLID BASE PLATE IS USED, TAPE
AROUND BOTTOM FLANGES OF CABINET
AROUND BOTTOM FLANGES OF CABINET
BEFORE THE UNIT IS INSTALLED.
BEFORE THE UNIT IS INSTALLED.
SOLID BASE FLANGE
FITS UNDER
CABINET BOTTOM
ST-A1220-10-X0
FIGURE 7
ST-A1220-08
ST-A1220-10
ST-A1220-11