Kobalt K18LD-26A Manual page 83

OPERATING INSTRUCTIONS
1. Charge the battery pack with the correct charger.
2. Connect the charger to a power supply.
3. Attach the battery pack to the charger by aligning the raised
ribs of the battery pack with the slot in the charger. Slide the
battery pack onto the charger (Fig. 1).
 7KH FKDUJHU ZLOO FRPPXQLFDWH ZLWK WKH EDWWHU\ SDFN¶V FLUFXLWU\
to evaluate the condition of the battery pack.
 7KH JUHHQ /(' OLJKW ZLOO ÀDVK FRQWLQXRXVO\ GXULQJ QRUPDO
charging.
6. After charging is complete, the green LED on the charger will
be on and the power indicator LED lights will turn off. The
power indicator LED lights will illuminate when the power
indicator button is pressed while the battery pack is off the
charger.
NOTICE: The battery pack will fully charge, but will not overcharge,
if left on the charger.
NOTICE: The charger may warm with several continuous charge
cycles. This is part of the normal operation of the charger. Always
charge in a well-ventilated area.
kobalttools.com
13