Control Pads On The Dehumidifier; Control Pads - Keystone KSTAD50B Owner's Manual

CONTROL PADS ON THE DEHUMIDIFIER

NOTE: The control panel of the unit you purchased may be slightly different according to the
models.
2 2
Bucket full
indicator light
1 1
Fig.1

Control pads

When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
Continue Pad
1 1
Press to activate the continuous dehumidifying
operation.
2 2
Filter Pad
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
3 3 Fan Pad
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
Filter
Full
Cont.
Cont. Cont.
7 7
Continuous
operation on
indicator light
Clean filter
indicator light
Turbo
Normal
Auto defrost
On Off
6 6 5 5
Timer on/off
indicator light
Power Pad
4 4
7 7
5 5
Timer Pad
6 6
Press to initiate the Auto start and Auto stop feature,
in conjuction with the
4 4
High fan
indicator light
4 4
Auto defrost operation on
indicator light
Press to turn the dehumidifier on and off.
: Up/Down Pads
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value(%).
For damper air, press the
percent value(%).
TIMER Set Control Pads
Use the Up/Down pads to set the Auto
start and Auto stop time from 0.0 to 24.
and
3 3
Low fan
indicator light
pad and set a higher
key pads.