Sony CDX--L460X Installation/Connections page 4

Precautions
•Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
•Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or near
heater ducts.
•Use only the supplied mounting hardware for
a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
Frequency select switch
The AM (FM) tuning interval is factory-set to the
9 k (50 k) position. If the frequency allocation
system of your country is based on 10 kHz
(200 kHz) interval, set the switch on the bottom
of the unit to the 10 k (200 k) position before
making connections.
Mounting example (4)
Installation in the dashboard
Mounting the unit in a Japanese
car (5)
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult
your Sony dealer.
Note
To prevent malfunction, install only with the
supplied screws 4.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
Be sure to press (OFF) on the unit for two
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) only momentarily, the
clock display does not turn off and this causes
battery wear.
RESET button
When the installation and connections are
completed, be sure to press the reset button with
a ballpoint pen, etc.
使用前注意事項
•本機請放在不妨礙司機駕駛之處。
•避免將本機放在高溫之處，如陽光直接照射、暖
氣機前、或灰塵極多、髒亂，以及極易受震動等
地方。
•為了安全起見，安裝時請使用附送的部件。
安裝角度之調整
請在 60 度以內調整安裝角度。
頻率選擇開關
AM（FM）調諧間隔在出廠前被設定在 9 k
（50 k）位置上。若貴國的頻率分配系統是以
10 kHz（200 kHz）間隔為基礎的，連接前，請將
本機底部上的開關設定在 10 k（200 k）位置
上。
安裝示例（4）
安裝在儀錶板裡
將本機安裝於日本產汽車上時
（5）
有的日本產汽車不能安裝本機，在這種情形下，請
您向當地的 Sony 經銷商諮詢。
註
為防止發生故障，安裝時只能使用附送的螺絲 4 。
安裝在點火鑰匙開關上沒有 ACC
（輔助）位置的汽車上時的警告
在關掉汽車引擎之後，一定請按下機器上的
(OFF) 兩秒以關掉時鐘顯示。
如果只短暫地按一下 (OFF)，將不會關掉時鐘顯
示而浪費電池。
復位按鈕
當安裝和連接完成後，務請用圓珠筆等按壓復位按
鈕。