Advertisement
Quick Links
Advertisement
Related Manuals for Traeger BBQ400.04
Summary of Contents for Traeger BBQ400.04
- Page 1 Assembly Instructions BBQ400.04 DOC136 REV A...
-
Page 2: Top Section
PARTS LIST PART PREVIEW DESCRIPTION PART# 1/4-20 SHOULDER BOLT LONG HDW154 WASHER 1/2OD X 1/4 ID FLAT ZINC HDW249 TOP SECTION 1/4-20 x .625 PHILLIPS PAN HEAD HDW066 Zinc 1/4 Lock Washer Zinc HDW113 1/4-20 x .500 Truss Head Screw Zinc HDW095 8-32 x .500 PPHD Zinc HDW245... - Page 3 Upper Hinge Assembly SUB309 Front Panel Assembly SUB260 BCA253 Grease Drain Assembly SUB254 Heat Baffle BCA289 Drip Pan BCA288 Porcelain Grills HDW093 HDW094 Washer 3/4 OD X 5/16 ID Zinc HDW250 Lower Back Panel Assembly SUB266 #8 X .375 Phillips Pan Head Zinc HDW244 1/4-20 X .500 Truss Head SST HDW095...
- Page 4 HARDWARE KIT BACK HARDWARE KIT FRONT...
- Page 5 1. Install fixed casters (M) onto the base stiffener located to the right of the base pan assembly (I). Secure using 4 each Phillips head bolt (D), lock washer (E) and washer (B) per caster. Install swivel casters (L) onto base stiffener located to the left of the base pan assembly.
- Page 6 4. Insert lower back panel assembly (AA) onto base pan assembly flush to the bottom and flush to the back. Insert the 3 screws (F) and washers (B) into the bottom holes and secure loosely. Insert the 6 screws (B) and washers (F) into the holes located on the inside of the back panel flange and secure loosely.
- Page 7 7. Before hopper installation ensure that the connector for the temperature probe is inserted into hole located on the right side of the hopper mounting face. Insert hopper burner assembly (N) onto BBQ on left side flush to the upper side panel.
- Page 8 10. Insert 3 each screws (BB) into holes provided on the inside of the shelf flange. Secure into the hopper top flange to secure hopper to the shelf. Loosen the screws for the shelf to adjust for alignment if needed. 11.
- Page 9 13. Insert upper door hinge (T) into hole provided on door left. Insert the door onto the lower pin located on the base pan. Insert screw (G) into hinge bracket and secure to the cabinet. Repeat the process on the right door. Adjust so the doors are even and open without interference.
- Page 10 16. Insert grease drain assembly (V) into the inside of the firebox and align with holes provided. Secure using 5 screws (BB) to the right sidewall and base of the firebox. 17. Insert heat baffle into the BBQ and insert into the notches in the clips located at the base of the firebox.
- Page 11 Ensure that the bucket is centered over the tube. Read the instruction manual before using your Traeger BBQ400.04. If you have any questions or problems contact Traeger Customer service. Contact information is located on the following page.
- Page 12 TRAEGER PELLET GRILLS, LLC BLDG R-1 10450 SW Nimbus STE A Portland, Or 97223-9904 TRAEGER TECHNICAL SUPPORT Available 7 Days a Week 5AM to 7PM Pacific Time TRAEGER PARTS DEPARTMENT Available Weekdays 8AM to 3:30PM Pacific Time TRAEGER SALES/ORDER DESK...