Installation; Wi-Fi Module Install - LG PWFMDD201 User Manual

User Manual

INSTALLATION

Wi-Fi Module Install

1. Verify that indoor unit is turned off and power is cut off at the outdoor unit's
input power circuit breaker.
2. Open the control panel of the indoor unit.
3. Connect USB connector to Indoor PCB (CN_WF).
Put a cable tie connected with the harness core in the control panel hole.
4. Connect USB harness to Wi-Fi module.
5. Attach the Wi-Fi Module on the wall with the tape.
CN_WF
Example of the installation
1 Installation example on the wall beside wired remote controller
!
NOTE
• Installation work must be performed in accordance with the national wiring stan-
dards by authorized personnel only.
• Installations must comply with the applicable local/national or international standards.
• If the product is not attached flat , it may fall.
• Wi-Fi module should be installed under the ceiling.
• Avoid to install Wi-Fi module in a place blocked by the wall.
• When installing the Wi-Fi module , do not bury it in the wall.
• Do not install the USB wire harness to be 21m or more. (It can cause communica-
tion error)
• Wi-Fi module should be installed within 10m from wireless router.
• If there is the wall or a barrier between Wi-Fi module and wireless router, communi-
cation will be not smooth. (It depends on wall construction or a barrier)
• Do not install Wi-Fi module around high humidity and temperature place.
※Other details, please refer to the Products manual.
Due to our policy of continuous product innovation, some specifications may change without notification.
"LG" is a registered trademark of LG Corp.
Indoor PCB
Control box
Control Panel
Roof
H = 200mm or more
Ceiling
USB Harness
Wi-Fi Module
Harness core
1
Direct
Sun ray contact area
no
no
yes
no
1.5 m
5