(Qty. 3) Products may be different from pictures and are subject to change without notice. TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable ™...
AC ground of the PoE. We recommend that you protect your networks from the most brutal environments and devastating ESD attacks with industrial-grade shielded Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable Hardware Overview Elevation Rod...
Hardware Installation Important: Carefully handle the Dish Antenna with Radome. Deformations in its shape may reduce the effectiveness of the RocketDish. 1. Attach the RF Cables to the connectors labeled Chain 0 and Chain 1 on the RocketM.
Page 5
2. Attach the RocketM to the Dish Antenna with Radome. a. Align the mounting tabs on the back of the RocketM with the Rocket mounting bracket. b. Slide the RocketM down to lock it into place.
Page 6
3. Attach the other end of the RF Cables to the RF connectors in this combination: Chain 1 to H and Chain 0 to V. *720-00057-01* 720-00057-01...
Page 7
4. Attach the Protective Shroud. a. Align the hash mark on the top of the shroud with the notch on the Dish Antenna with Radome. b. Rotate the shroud clockwise until it locks into place.
Page 8
5. The Elevation Rod includes washers and nuts. Remove one nut, one spring lock washer, and one washer. Use them to secure the Elevation Rod when assembling. 6. Attach the Elevation Rod to the Mounting Bracket. a. Insert the Elevation Rod into the Mounting Bracket. b.
Page 9
9. Each M10x25 Carriage Bolt includes a washer, spring lock washer, and nut. Remove these and use them to secure the bolts when assembling. 10. Attach the RocketDish to the Mounting Bracket. a. Insert one M10x25 Carriage Bolt into the RocketDish and Elevation Rod.
Page 10
11. Each M10x100 Bolt includes a washer, spring lock washer, and nut. Remove these and use them to secure the bolts when assembling. 12. Attach the Stabilizer Brackets to the pole just beneath the area where the RocketDish will be attached. Note: The mounting assembly can accommodate a Ø...
Page 11
13. Attach the Mounting Bracket to the pole just above the Stabilizer Brackets. a. Slide a Pole Clamp over each pair of M10x170 Carriage Bolts. b. Secure each M10x170 Carriage Bolt with one washer, one spring lock washer, and one nut.
Page 12
14. Visually align the azimuth and elevation. a. To adjust the azimuth, rotate the RocketDish while it is supported by the Stabilizer Brackets. b. To adjust the elevation angle, tighten or loosen the nuts on the Elevation Rod so that the RocketDish is set to the desired tilt.
Specifications RocketDish RD-5G31-AC Dimensions 748 x 748 x 349 mm (29.45 x 29.45 x 13.74 in) Weight 7.6 kg (16.76 lb) (Mount Included) Frequency 5.1 - 5.8 GHz Gain 31 dBi Max. VSWR 1.4:1 Wind Survivability 200 km/h (125 mph)
Safety Notices Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm.
Ubiquiti MAC label, or is missing any other original Ubiquiti label(s). (VII) has not been received by Ubiquiti within 30 days of issuance of the RMA. In addition, the above warranty shall apply only if: the product has been properly installed and used at all times in accordance, and in all material respects, with the applicable Product documentation;...
Page 16
No Products will be accepted for replacement or repair without obtaining a Return Materials Authorization (RMA) number from UBIQUITI NETWORKS during the warranty period, and the Products being received at UBIQUITI NETWORKS’ facility freight prepaid in accordance with the RMA process of UBIQUITI NETWORKS.
Limitation of Liability EXCEPT TO THE EXTENT PROHIBITED BY LOCAL LAW, IN NO EVENT WILL UBIQUITI OR ITS SUBSIDIARIES, AFFILIATES OR SUPPLIERS BE LIABLE FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL OR OTHER DAMAGES (INCLUDING LOST PROFIT, LOST DATA, OR DOWNTIME COSTS), ARISING...
Page 18
Compliance RF Exposure Warning The antenna and transmitter must be installed to provide a separation distance from all persons and must not be located or operating in conjunction with any other antenna or transmitter. For the specific separation distance, refer to the Quick Start Guide for your RocketM device (transmitter).
Page 19
RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Page 20
Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Page 21
Italiano La direttiva europea 2002/96/EC richiede che le apparecchiature contrassegnate con questo simbolo sul prodotto e/o sull’imballaggio non siano smaltite insieme ai rifiuti urbani non differenziati. Il simbolo indica che questo prodotto non deve essere smaltito insieme ai normali rifiuti domestici.
UBIQUITI NETWORKS device, megfelel a vonatkozó alapvetõ [Hungarian] követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak. Íslenska Hér me l sir UBIQUITI NETWORKS yfir ví a UBIQUITI NETWORKS device, er í samræmi vi grunnkröfur og a rar kröfur, sem ger ar eru í [Icelandic] tilskipun 1999/5/EC.
Page 23
NETWORKS device, è conforme ai requisiti essenziali ed alle altre [Italian] disposizioni pertinenti stabilite dalla direttiva 1999/5/CE. Latviski Ar o UBIQUITI NETWORKS deklar , ka UBIQUITI NETWORKS device, atbilst Direkt vas 1999/5/EK b tiskaj m pras b m un citiem ar to saist [Latvian] tajiem noteikumiem.