Installing The Essentia System In Your Home - Nuvo Essentia NV-E6GMS-DC Installation Manual

Installing the Essentia System in Your Home

I. Prewire
The Essentia System uses CAT5 cable for Control Pad control and either two or four-conductor 16-gauge speaker wire. All the wire
is "homerun" from each zone to the location of the Essentia amplifier and Audio Source equipment.
Complete CAT5 Crimping Instructions
The NuVo audio systems require CAT5, unshielded, twisted
pair (UTP) for communication between the Control Pads and
the main amplifier unit. Each end of the wire is terminated
with an RJ45 connector.
The Essentia System can accommodate 2,000 total feet of
CAT5 cable. For the most reliable operation, it is best that no
single run of CAT5 exceeds 250 feet.
The correct wiring scheme for the CAT5 cable is standard
EIA/TIA 568A, or 568B. Properly terminating the CAT5 cable
is crucial for the operation of the system. It is very
important to use a good quality crimp tool, and test each
end to end run with a CAT5 wire tester to insure that your
system operates flawlessly, Fig.1.
Step-by-Step Crimping Instructions:
1. Strip a 2 to 3 inch portion of the insulation, exposing
the 4 twisted pairs.
2. Untwist the wires and fan them out individually.Arrange
the wires into the correct color scheme as shown in Fig.
1.
3. Flatten the wires in their correct order and trim them
evenly across the top. Most crimp tools have a wire
trimmer built-in. It is best to trim the wires to about ½"
in length.
4. While holding the wires flat between your thumb and
forefinger, insert the wires into the Rj45 connector so
each is in its own slot. Push the wire into the RJ45 so all
8 conductors touch the end of the connector. The
insulation jacket should extend beyond the crimp point
of the RJ45.
5. Insert the RJ45 into the crimp tool receptacle and
squeeze the tool firmly. Note that a ratchet type
tool should tighten down until it no longer clicks.
6. The RJ45 should be firmly crimped to the CAT5
insulation. It is necessary that the color scheme be
repeated identically on each end of the wire.
7. Test each termination with a CAT5 Tester before
completing the installation.
Top view with
tab down.
Fig. 1: EIA 568A and 568B wiring scheme for CAT5 Cable
Pin # 568A
1. Green Stripe
2. Green
3. Orange Stripe
4. Blue
5. Blue Stripe
6. Orange
7. Brown Stripe
8. Brown
Note: Colors listed as "stripe" are a white wire
with a colored stripe.
Step 1 Step 2
Step 4 Step 5
11
1 2 3 4 5 6 7 8
Pair 2 Pair 1 Pair 4
Pair 3
Wires insert from
this end.
Pin # 568B
1. Orange Stripe
2. Orange
3. Green Stripe
4. Blue
5. Blue Stripe
6. Green
7. Brown Stripe
8. Brown
Step 3
Step 6