Table of Contents
Advertisement
THE PERFECT FIT
Handlebar Component Fastener Torques
IMPORTANT: Moving a handlebar component without first loosening its
screws/set screws may cut grooves into the handlebar, making it difficult
to secure the component. Do not move a handlebar component without
first loosening its mounting screws/set screws.
Take care to avoid damaging hand warmer/brake switch wires when
moving components.
1.
Left Hand Control/Brake Master Cylinder
2.
Upper / Lower Handlebar Clamps
3.
Throttle Lever Block Set Screw
4.
Throttle Lever Block Cover Screws
5.
Auxiliary Engine Stop Switch Set Screw
6.
Riser
Hand Guard Mounts (if applicable)
52
Component
Torque
Do not over-tighten
24 in-lbs (2.7 Nm)
16 ft-lbs (21.6 Nm)
27 in-lbs (3 Nm)
6 in-lbs (0.7 Nm)
12 in-lbs (1.4 Nm)
Install with the "FWD"
stamp facing forward,
toward the hood.
Hand-Tight
Advertisement
Table of Contents
