Table of Contents
Advertisement
Connections
5.
Insert a screw clockwise into the hole on the rear of the speaker
using a screwdriver.
And then connect a speaker cable.
6.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
Installing the Speakers on the Tallboy Stand
* HT-F5530HK only - Front Speakers
* HT-F5550HK only - Front/Surround Speakers
1.
Turn the Stand Base upside-down and connect it to the Speaker.
2.
Use the driver to combine the screws on the 3 marked holes.
Installing a speaker is finished. Follow the same steps to install
other speakers.
3.
If you want to adjust the height of the speaker, loosen a screw
on the rear of the speaker base first.
4.
Pull up the speaker in the arrow direction. (Be careful as an
excessive force may result in a physical damage.)
5.
Fit the speaker in a height adjusting a hole, and then use a screw
to fasten a speaker.
6.
This is appearance of after the speaker is installed and height
adjusted. To adjust height of other speakers, follow the step 3 ~ 5.
Connecting The Speakers
1.
Match each speaker cable bundle to the correct speaker by matching the colour coded
plug on each bundle to the coloured sticker on the bottom of each speaker.
2.
To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire, and then
release the tab.
b. Press down the black tab on the back of the speaker, insert the black wire, and then
release the tab.
3.
Connect the speaker wire plugs from each speaker to the back of the product by
matching the colours of the speaker plugs to the colours of the speaker jacks.
16
|
English
5
6
Stand Base
1
2
Speaker
3
4
5
6
Black
or
Red
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
