Table of Contents
Advertisement
Installing the Nexus N-3030
2. Position the scanner as indicated in the figure below and rotate the scanner
around the cover. Make sure that connectors and cables are placed as
indicated in the figures, to allow easy attachment of the scanner to the end
cover. Press the scanner until a "click" is heard.
3. Plug the remote ends of all cables into the appropriate connections of your
host POS-system.
4. If you are using an external power supply, power on the scanner by
connecting the IEC power cord to the AC/DC power supply and plugging the
AC power cord into an AC power outlet. Switch on the host system.
IMPORTANT
To activate Data port 2 (OCIA or KBW interface) scan the following
codes from the Configuration Guide:
1. open the scanner Programming Mode by scanning code 1.1
2. return to factory default settings by scanning code 1.3
Once the scanner is installed, you can start scanning bar code labels. If you
want to change the default settings of the scanner, proceed to the Configuration
Guide which came with the scanner.
15
Advertisement
Table of Contents
