Table of Contents
Advertisement
If the transmitter status LED
doesn't light green, check the
polarity of the batteries. If you
see any other flashing signal
from the LED, refer to the
chart on page 40 to identify
the code.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries. Do not use
rechargeable AA cells to
power the TQi transmitter,
as they will not provide
sufficient voltage for optimum
transmitter performance.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light on the transmitter) to
avoid losing control.
3
10 • JATO 3.3
TRAXXAS TQ
RADIO SYSTEM
i
INSTALLING RECEIVER BATTERIES
The radio receiver in your Jato uses 4 AA batteries (or rechargeable
NiMH batteries, see below). The receiver battery holder is located in
the battery compartment on the rear skid plate of the vehicle.
Rear Mounting (Stock)
1. Unscrew the four 2.5x10mm
cap screws on the rear
battery box cover with the
provided 2mm wrench and
remove the rear cover.
2. Remove the AA battery
holder and install 4 AA
alkaline or rechargeable
batteries. Make careful note of the
battery polarity by comparing against the
diagrams in the battery holder.
3. Install the battery holder into the rear battery compartment.
4. Replace the battery compartment cover and reinstall the four screws.
Installing an RX Power Pack (Optional)
Jato gives you the option of mounting a 5-cell NiMH RX Power Pack
in either the rear or mid position.
Rear Mounting (Optional 5-cell RX Power Pack only)
1. Unscrew the four 2.5x10mm cap screws
on the rear battery box cover with the
provided 2mm wrench and remove the
rear cover. Remove the body clip that
secures the mid battery compartment
cover and remove the cover.
2. Remove the AA battery holder and follow
its wire to the mid battery compartment.
Disconnect the AA battery holder from the
connector in the mid battery compartment.
3. Route the wire from the RX pack to the mid battery compartment.
Plug the 5-cell RX Power Pack into the connector.
4. Install the 5-cell RX Power Pack into the rear battery box, carefully
positioning the wires into the slots so that they will not be pinched
when both battery covers are reinstalled.
5. Replace the rear battery compartment cover and reinstall the four
screws. Replace the mid battery box cover and secure with the body clip.
Mid Mounting (Optional 5-cell RX Power Pack only)
1. Remove the body clip that secures
the mid battery compartment cover
and remove the cover.
2. Pull out the battery connector,
disconnect the wire for the
AA battery holder in the rear
compartment, and plug in the
5-cell RX Power Pack.
3. Install the 5-cell RX Power Pack into
the mid battery box.
4. Replace the mid battery box cover. Do not allow the wires to be
pinched by the cover. Secure the cover with the body clip.
Your model can be upgraded with
the RX PowerPack NiMH rechargeable
receiver battery (part #3036). This battery
eliminates the 4-cell battery holder and
the need to replace alkaline batteries.
A special wiring harness (part #3034) is
required for the Jato (includes a handy external charging jack).
Traxxas' integrated TRX Power System is the easiest way to add
the power and economy of rechargeable batteries to your Jato 3.3.
Consult your hobby dealer for purchasing information.
Advertisement
Table of Contents
