Mitsubishi Electric MSZ-FH25VE - E1 Service Manual page 19

(4) Press button to complete and transmit the weekly timer setting.
NOTE:
• Press button to transmit the setting information of weekly timer to the indoor unit. Point the remote controller toward the
indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
setting. Press button once after all the settings are complete. All the weekly timer settings will be saved.
• Press button to enter the weekly timer setting mode, and press and hold
timer settings. Point the remote controller toward the indoor unit.
(5) Press button to turn the weekly timer ON. (
•When the weekly timer is ON, the day of the week whose timer setting is complete, will light.
Press button again to turn the weekly timer OFF. (
NOTE:
The saved settings will not be cleared when the weekly timer is turned OFF.
2. Checking weekly timer setting 2. Checking weekly timer setting
(1) Press button to enter the weekly timer setting mode.
* blinks.
(2) Press or
(3) Press button to exit the weekly timer setting.
NOTE:
When all days of the week are selected to view the settings and a different setting is included among them,
displayed.
9-9. i-see CONTROL ( ) MODE
In the i-see control mode, the room temperature is controlled based on the sensible temperature.
(1) Press SENSOR button with a thin instrument during COOL, DRY, HEAT and AUTO mode to activate i-see control mode ( ).
The default setting is "active".
(2) Press SENSOR button again to activate ABSENCE DETECTION ( ).
(3) Press SENSOR button again to release i-see control mode.
ABSENCE DETECTION ( )
This function automatically changes the operation to energy-saving operation when nobody is in the room.
(1) To activate this function, press SENSOR button until
i-see control mode.
(2) Press SENSOR button again to release ABSENCE DETECTION.
9-10. INDIRECT/DIRECT MODE
The INDIRECT/DIRECT mode offers fi nely-tuned operation by locating where an occupant is in the room.
(1) Press INDIRECT/DIRECT button during COOL, DRY, HEAT or AUTO mode to activate INDIRECT/DIRECT mode.
This mode is only available when the i-see control mode is effective.
(2) Each press of INDIRECT/DIRECT button changes INDIRECT/DIRECT in the following order:
(INDIRECT) (DIRECT)
(INDIRECT) : An occupant will be less exposed to direct airfl ow.
(DIRECT) : Mainly the vicinity of an occupant will be air-conditioned.
NOTE:
• Horizontal and vertical airfl ow directions will be automatically selected.
• If you still feel uncomfortable with the air direction determined by the INDIRECT mode, adjust the air direction manually.
• Cancelling the i-see control mode automatically cancels the INDIRECT/DIRECT mode.
INDIRECT/DIRECT mode is also cancelled when the VANE or WIDE VANE buttons is pressed.
• Do not touch the i-see SENSOR. This may cause malfunction of the i-see SENSOR.
OBH623D
* which was blink-
ing goes out, and the
current time will be
displayed.
buttons to view the setting of the particular day or number.
(OFF)
button does not have to be pressed per each
lights.)
goes out.)
appears on the operation display of the remote controller during the
19
button for 5 seconds to erase all weekly
will be