Operation With The Remote Control; Initial Settings - Technika LCD26-920 Operating Instructions Manual

Operation with the Remote Control

• The remote control of your TV is designed to control
all the functions of the model you selected. The
functions will be described in accordance with the
menu system of your TV.
• Functions of the menu system are described in the
following sections.
Volume Setting
• Press "V +" button to increase the volume. Press "V
-" button to decrease the volume. A volume level
scale (slider) will be displayed on the screen.
Programme Selection (Previous or Next
Programme)
• Press " P - " button to select the previous
programme.
• Press " P + " button to select the next programme.
Programme Selection (Direct Access)
• Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between 10 - 299 (for IDTV) or 10-199 (for analogue),
press the numeric buttons consecutively. The limit
of the delay time is 3 seconds.
• Press directly the programme number to reselect
single digit programmes.

Initial Settings

When the TV is turned on for the  rst time, the menu
for the language selection appears on the screen. The
message "Welcome please select your language!"
is displayed in all language options sequentially in
the OSD.
By pressing the " " or " " buttons highlight the
language you want to set and press OK button. After
then, "First time installation" OSD will appear on the
screen.
By pressing " " or " " buttons, select the country
you want to set and press OK button. button (** for
EU countries).
Note: Country selection OSD will not be available
for UK.
After then, the active antenna selection OSD appears
on the screen:
By pressing " " or " " buttons, set active antenna
mode as on or off.
[GB]_MB35_COST_26857WS_1810UK_PANEUIDTV_SILVER1_TECHNIKA_10064934_50155702.indd 12
If an active antenna is connected to your TV, you
can select this option as On. Antenna power should
be "Off" when standard antenna is used instead of
the active antenna. See Con guration Menu in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the
item by using " " or " " buttons and press the OK
button.
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"M" button at any time during the process.
After Automatic Search is completed, the following
message asking for analogue channel search appears
on the screen:
To search for analogue channels, select "Yes". TV
switches to the analogue TV mode. The menu below
is displayed to search for analogue channels:
English - 12 -
02.10.2009 09:31:41