Rail King 4-6-0 Steam Freight/Passenger Set Operation Manual

Hide thumbs Also See for 4-6-0 Steam Freight/Passenger Set:

Advertisement

Quick Links

www.railking.com
4-6-0 Steam Freight/
Passenger Set
Operation Manual
Thank you for purchasing this RailKing product.
PLEASE READ BEFORE USE AND SAVE

Advertisement

Table of Contents
loading

Summary of Contents for Rail King 4-6-0 Steam Freight/Passenger Set

  • Page 1 www.railking.com 4-6-0 Steam Freight/ Passenger Set Operation Manual Thank you for purchasing this RailKing product. PLEASE READ BEFORE USE AND SAVE...
  • Page 2: Table Of Contents

    Z-750: 21VAC 3.75A 75W; Z-1000: 14VAC 80W or 18VAC 100W This product may be protected by one or more of the following patents: 6,019,289; 6,280,278; 6,281,606; 6,291,263; 6,457,681; 6,491,263; 6,604,641; 6,619,594; 6,624,537; 6,655,640. ©2005, M.T.H. Electric Trains, Columbia, MD 21046 RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 3: Set Up Checklist

    Microphone w/1/8” Plug 1/8” Male to Male Plug Cassette Player You can obtain replacement parts and replacement instructions from the M.T.H. Parts Department e-mail: parts@mth-railking.com phone: 410-381-2580 mail: 7020 Columbia Gateway Drive, Columbia MD 21046-1532 RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 4: Getting Started

    Connect the Wires from the Z-Controller to the Lighted Lock-On, being sure that the wires are connected from red-to-red and black-to-black. Unplug when not in use Also functions as a binding post. Red Harness Wire/Plug Black Harness Red Harness Black Harness Wire/Plug Wire/Plug Wire/Plug RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 5: Lubricating The Engine

    Smoke Unit ON/OFF Switch STEP STEP STEP Incorrect Push cars together to Place the engine and cars Position couple. on the track. Open couplers by pressing down on plunger. Position armature for proper operation RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 6: Remote Control

    If they match you ! Plug tender plug into boiler socket at the back of cab. may connect those two pieces; if not, don't. Connect the draw bar between the engine and tender. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 7: Basic Operation

    Each time you shut down the engine completely, it will automatically turn speed control on. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 8: Direction Lock

    Plug Cable into the "Audio" port on the right side of the remote lock-on. Adjust the volume. If engine sounds keep breaking through the recorded sounds, increase the volume on the audio source. 1/8" plug Proto-Cast Proto-Dispatch Proto-Cast RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 9: Manual Volume Control

    To adjust the volume of all sounds made by this engine, turn the master volume control knob located under the tender clockwise to increase the volume and counter-clockwise to decrease the volume. increase RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 10: Maintenance

    Thereafter, keep an eye on the track and clean it when it gets dirty to ensure good electrical contact and to lengthen the life of the tires. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 11: Locomotive Traction Tire Replacement

    Otherwise your engine will wobble while operating. ! Make sure the tire is fully seated inside the groove. Use a razor blade to trim away any excess tire that doesn't seat itself inside the groove properly. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 12: Smoke Unit Maintenance

    If it is darkly discolored and hard, it should be replaced. When priming new wick add 40 drops. Running the engine without a primed smoke unit may cause damage RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 13: Locomotive Light Bulb Replacement

    Remove these four screws STEP 2) With the four screws removed, lower the chassis from the shell, take care not to pull the wires out. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 14 4) You can now replace the bulbs by pushing the socket up from the bulb holder and pull the bulb from its socket. Replace with a new one, and reverse the steps to reassemble the caboose. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 15: Railware Interactive Cd Rom

    *If you are running Windows 95, 98 or NT choose the folder 32 BIT. Run the file AR32E301.EXE and follow the directions it provides. If you have problems you cannot resolve by using these directions, contact custserv@mth-railking.com or call 410-381-2580 for further help. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 16: Troubleshooting

    Sound engines in the same range will also pick up the the Proto-Cast and Dispatch sounds sound. Try moving one of the sets. play from both engines, not just from the one connected to the audio source or microphone. RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 17: Compatibility

    110-Watt Standard Lionel SW Unknown 130-Watt Standard Lionel TW 8-18v 175-Watt Standard Lionel ZW A,B,C or D 8-20v 275-Watt Standard Lionel Post-War A,B,C or D Common 0-20v 135/190 Watt Electronic Celebration Series ZW RailKing 4-6-0 Steam Freight/Passenger Set with Loco-Sound™...
  • Page 18: Service And Warranty Information

    Service & Warranty Information How to Get Service Under the Terms of the Limited One-Year Warranty When you suspect an item is defective, please check the operator's manual for standard operation and trouble-shooting techniques that may correct the problem. Additional information may be found on the M.T.H.

Table of Contents