Features & Controls; Control Functions - Ferris 5900784 Operator's Manual

Features & Controls
Features and Controls

Control Functions

The information below briefly describes the function of individual controls. Starting, stopping, driving, and
mowing require the combined use of several controls applied in specific sequences. To learn what combination
and sequence of controls to use for various tasks see the OPERATION section.
Ground Speed Levers
These levers control the ground speed of the rider.
The left lever controls the left rear drive wheel and
the right controls the right rear drive wheel.
Moving a lever forward increases the FORWARD
speed of the associated wheel, and pulling back on a
lever increases the REVERSE speed.
Note: The further a lever is moved away from the
neutral position the faster the drive wheel will turn.
See the Operating the Zero Turn Rider section for
steering instructions.
14
A
Seat Adjustment Lever
The seat can be adjusted forward and back. Move
the lever to the left, position the seat as desired then
release the lever to lock the seat in position.
Ignition Switch
The ignition switch starts and stops the engine, it has
three positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and
powers the electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped–this drains the
battery.
www.ferrisindustries.com