Kenwood DNN9150BT Instruction Manual page 111

Return to the Top page
Setting Up
Language setup
1
Touch [SET] of [Language] in the User
Interface screen.
Language Setting screen appears.
2
Set each item as follows.
GUI Language Select
Select the language used for the GUI and input
methods.
Navigation Language Select
(DNN9150BT/ DNN9150BTM)
Select the language used for navigation.
STT
Select the language used for Speech to Text
(STT).
TTS
Select the language used for Text to Speech
(TTS).
3
Touch [Enter].
NOTE
• To cancel the language setup, touch [Cancel].
110
Learning function of steering remote
This function is available only when your
vehicle is equipped with the electrical
steering remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch [SET] of [Steering Remote
Controller] in the User Interface screen.
Steering Remote Controller Setting screen
appears.
2
Press the steering remote controller
button you want to set the function.
NOTE
• You can have the unit learned all buttons at a
time. In that case, press the all buttons one at a
time and after pressing all of them, touch [Done]
in Steering Remote Controller Setting screen.
However, new functions cannot be learned after
this operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [Done].
NOTE
• When changing the function already learned,
touch the button you want to change in step 2
and then touch to select the changed function
from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [Initialize] of
[Steering Remote Controller] in User Interface
screen. After you touch [Initialize], a confirmation
message appears. Follow the message and
complete the operation.