Adjustments; Functional Alignment (1) - Sony SDM-S51 Service Manual

2-1. FUNCTIONAL ALIGNMENT (1)

•Procedures of how to go to service mode.
1. Hold "C" and "B" key power on, SDM-S51 goes into service mode.
2. Press "MENU" key-----ODS display → contigulation → RGB Reset → ΟΚ → contigulation → Color Temp.
3. Press "-" key to go to second page's late icon.
4. Press "OK" key-----service menu display.
5. Select one of features.
6. Press "MENU" key to exit OSD.
7. Power OFF then ON again, monitor go to normal mode.
If you would like to enter service mode again, performing the above procedures cycle.
Note
1. N/A means "Not applied".
2. This service menu only provides both Configuration & Sync slice functions.
This other were used for design engineering.

ADJUSTMENTS

OK
CONFIGUR ATION
(N/A)
CHIPS
SYNC SLICE
(N/A)
EXIT
There is no guarantee of using those N/A functions.
SECTION 2
ANALOG
2 COLO R TEMP
INITIAL EE PROM
CLEAR ETI TIME
1 RGB RESET
EEPROM TEST
INITIAL EE PRM
EXIT
PERFORM
On
Off
9300K
6500K
5000K
SUB-BRIGHTNESS
R
G
EXIT
B
SUB-CONTRAST
R
G
B
EXIT
SDM-S51(E) 2-1