Table of Contents
Advertisement
[ When removing the DVD Deck ]
Before removing Pick Up PCB and DVD PCB connector, the short circuit the position shown in Fig. 1
using a soldering iron. If you remove the DVD Deck with no soldering, the Laser may be damaged.
[ When installing the DVD Deck ]
Remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD
PCB connector.
NOTE
•
Before your operation, please read "PREPARATION OF SERVICING".
•
Use the Lead Free solder.
•
Manual soldering conditions
• Soldering temperature: 320 ± 20˚C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
•
When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to keep the
Flux smoke away from it.
WHEN REPLACING DVD DECK
Pick Up PCB
Short circuit using a
soldering iron.
Fig. 1
A1-2
Advertisement
Table of Contents
