Toshiba TL968 series User Manual page 18

SETTING UP YOUR TV
NOTE:
• None is being used when the satellite dish will
control only one universal Low Noise Block (LNB)
with a single satellite (e.g. Astra 19.2°). As a rule,
most households use just one satellite.
• ToneBurst sends a 22kHz signal. ToneBurst is only
necessary for simple LNBs (not universal LNBs). The
22kHz signal is needed for switching LNBs with
multifeed signals as well as for changing between
low- and high-band.
• DiSEqC 2way automatically switches between two
LNBs, which receive different satellites at the same
time (e.g. Astra 19.2° and Hotbird 13°).
• DiSEqC 4way automatically switches between up
to four LNBs / satellites.
• Single cable is selection and control of plural
Satellite antennas through the combined single
antenna cable.
The setting LNB Power enables you to switch on or
off the LNB's power supply by means of the TV. When
your satellite dish consists of only one LNB, LNB
Power should generally be activated (On). When
using more than two LNBs, it is recommendable to
use external power supply for these.
Satellite Settings
Switch Type
LNB Power
No. Satellite
ASTRA 19.2˚E
1
2
3
4
Transponder: 1/85 (10729 MHz)
Dish Type: Fixed
Lower LOF: 9750
Upper LOF: 10600
It is possible to select up to four satellites. Please note
that the number of available LNBs and the adjustment
of your satellite dish determines the number of
satellites found. For example, it is not possible to
receive more than one satellite if your dish is directed
to a single satellite. For further information on
satellite signal technology, please contact your local
dealer.
None
On
Dish LNB
1 1
Done
Satellite Settings
Switch Type
LNB Power
No.
ASTRA 19.2˚E
1
2
3
4
Transponder: 1/85 (10729 MHz)
Dish Type: Fixed
Lower LOF: 9750
Upper LOF: 10600
Once you have selected a satellite, you can change
further settings under Dish and LNB.
C c
Press OK /
Press OK.
Under Dish you choose the dish type that will be
used (fixed or moveable dish). The majority of
households have a fixed satellite dish.
LNB allows you to determine the lower and higher
Local Oscillator Frequency (LOF). Usually, the factory
settings do not need to be changed. You can find the
parameters of the lower and higher LOF on the
specification sheet of your LNB.
Satellite Settings
Switch Type
LNB Power
No.
ASTRA 19.2˚E
1
2
3
4
Transponder: 1/85 (10729 MHz)
Dish Type: Fixed
Lower LOF: 9750
Upper LOF: 10600
Highlight Done and press OK.
18
None
On
Satellite Dish
1
Done
to select Dish or LNB.
None
On
Satellite Dish
1
Done
LNB
1
LNB
1