Table of Contents
Advertisement
3 To access the memory slot, follow the steps below:
a Remove the screws from the support bracket as illustrated below.
b Remove the support bracket.
c Lift the air duct upwards.
4 To insert the new memory module, follow the steps below:
a Release the ejectors on the memory slot by pushing them outwards.
b Align the notch on the gold edge of the module with the notch in the memory slot.
c Use two fingers to apply firm, even pressure and push the memory module downward.
d When the memory is inserted correctly, the ejectors will snap into place.
Important:
To avoid damaging the memory module, please hold it by the edges and do not touch the gold
connectors.
5 Replace the top cover, slide it into place, and tighten the two screws on the back of your RackStation.
Make Sure RackStation Recognizes New Memory Capacity
After installing a new memory module in your RackStation, we recommended checking whether the system
recognizes the new memory.
To check the memory of your RackStation:
1 Start up your RackStation. (See "Start Up Your RackStation" on Page 15 for more information.)
2 Install DSM. (See "Chapter 3:
3 Log in to Synology DiskStation Manager (DSM).
10 Chapter 2: Hardware Setup
Install DSM on RackStation
" on Page
17 for more information.)
Advertisement
Table of Contents
